Step 7 - Installing aluminum roof panels:
7a)
Place the two aluminum roof caps over the top of the blind.
7b)
Once the metal roof panels are in place, slide the center connecting strip between the
two tracks on the roof panels which will secure the two roof panels together. Be careful when pushing the connecting strip across the 2 panels so not to
bend. Use two hands to work the connecting strip carefully across the panels from one end of the blind. Leave the same amount of overhang on each end of
blind.
7c)
Starting from the top of the roof fasten the metal roof to the walls of the blind using the (3/4”) green screws. Push down on the roof cap while driving
in the screws ½” up from the bottom of the roof edge. The 2 blind sides will use eight screws and the front and back will use six. Make sure all four corners
have a screw in each side. Start in center and move to the outside.
7d)
Bend down the overhang from the center connecting strip fl ush with front wall and back wall. Trim the aluminum connector so it’s even or slightly past
the roof cap and fasten down with two (3/4”) green screws.
7a
7b
7c
7c
7d
7d
