Step 5 - Installing corner molding:
5a)
Caulk the four corner moldings with caulk provided with a generous bead 1/4” from the side of the trim piece on both sides.
5b)
Attach corner molding
fl ush to the bottom of the blind to and fasten with six (3/4”) green screws (per side) starting from the middle to the top and then middle to the bottom in
pre-drilled holes.
5c)
Push in on corner molding when driving screws to ensure corners are drawn in tight.
Step 6 - Installing interior center 2” X 2” roof support board:
6a)
Install the wooden center roof support board in the center of the ceiling fastening the 2” black fl at head screws in the pre-drilled holes. Ensure that the
screw connects with the roof core and draws down and that the screws do not protrude out the top of the roof core as this could puncture the aluminum
roof panel when installed in step 7.
6b)
Install the two (3”) fl at head screws into each end of the support board through the top center pre-drilled front and
back panels.
5a
5b
5c
6a
6a
6b
Step 4 - Installing roof core panels:
Install the two-insulated roof cores in place on top of the blind over the wall cleats. You may need to loos-
en outside top 2” wall screws to fi t in place. Make sure roof panel is fl ush on all four sides and fasten the
side walls fi rst with three 2” screws through the pre-drilled holes. Now secure the roof cap from the front
with four 2” screws and fi nally the back with four 2” screws. Push down on the roof cores when driving
the screws into the cores. *Be careful not to crush the aluminum panel by over-tightening.
