Shademaker Orion OR-27S, Руководство пользователя

Страница: 7 / 12

5 6
A S S E M B L Y I N S T R U C T I O N S
Two-person team is recommended for assembly.
By now, you have installed your mount kit, SM PLATE onto your steel base weight, or
have set up your steel base frame with recommended base weight.
(Astral-TC Internal Stem shown)
(Astral-TC Internal Stem shown)
Slide internal stem cover over bottom of Orion mast. Using a two person team, lift
umbrella with cover and insert bottom of mast onto internal stem. Tighten 5 bolts to
secure umbrella in place with allen wrench.
Note:
Do not use power drill. May cause
damage to umbrella. Slide internal stem cover down to cover internal stem.
Installing Internal Stem
Option A: If you wish to use optional internal stem cover, proceed below.
Otherwise, if you wish to not use cover and for a quicker installation, skip to
Option B on page 6.
Remove internal stem from bottom of mast by removing the three bolts underneath the
turning handle.
Note:
Do not remove the bolt above the turning handle!
Install internal stem onto mount kit, SM PLATE or steel base frame with supplied 5 bolts
and washers using allen wrench.
Do not completely tighten
.
Note:
Do not use power
drill. May cause damage to umbrella.
Unpack the Orion and lay it out on a clean, soft surface.
Slide the boom over the elbow and secure with supplied
fastening screws.
Note:
Be careful to not knick the cord.
Internal Mast Stem Cover Installed
Attaching Orion to Internal Stem
Lift rotating handle from mast. Rotate Orion mast until the bore holes for the locking
screws in the internal stem line up in the mast. Tighten locking screws with allen wrench
into the mast and internal stem to secure.
Note:
Do not use power drill. May cause
damage to umbrella. Once complete, proceed to “Leveling Umbrella” on page 7.
Bore Holes