7
I M P O R T A N T :
Insert the Spacer Buttons Immediately!
It is imperative that the eight (8) spacer buttons (white plastic cups/screws) are inserted
after the canopy is opened for the first time. Spacer buttons stop the arms from closing
completely and make it much easier to open the canopy singe-handedly.
When opening the canopy for the first time, the arms will have to be helped open
manually to facilitate cranking. Never force the arms. Once the canopy is open, insert
the spacer buttons. Holes have been predrilled and you will need to insert the spacer
buttons (white plastic cups/screws), one per arm.
A S S E M B L Y I N S T R U C T I O N S
By now you have installed your base plate(s) or in-ground fitting and bolted your internal
stem to the base plate or in-ground fitting.
1. Unpack the Orion and lay it out on the ground as in the drawing, assuring the
crank (
3
) is facing upwards.
2. Slide mast (
6
) over newly mounted internal stem (
1
). Make sure the mast sits on
the acetal ring (
2
). Insert locator pin (
16
) through mast and internal stem (
1
). If
the mast is properly seated and the locator pin is properly inserted, the Orion will
not rotate or lift.
3. Using a step ladder, fasten the boom (
19
) to the elbow (
7
) by inserting and
tightening the four screws provided (two on each side). Or attach the boom to
the mast while laid out on the ground, and then lift the entire mast and boom
and
slide over mast as described above.
4. Connect the sister clips on canopy structure and on wire/rope.
5. Slide the canopy structure into the head fitting (
8
) by aligning the set screw (
20
)
on the top of the canopy structure with the slot in the head fitting (
8
).
1
2
8
20
19
7
6
3
16
1
2
Содержание Orion 2.5
Страница 1: ......
