2
I M P O R T A N T :
Please read this entire manual before installing or operating your Galaxy umbrella.
G A L A X Y W I N D R E S I S T A N C E G U I D E L I N E S :
Moderate Winds (when mounted)
When installed properly, the Galaxy is engineered to handle moderate wind
conditions in the open canopy position. Please adhere to these wind guidelines:
1. As winds get stronger or as gusts increase, the canopy should be lowered to the
folded and strapped position.
2. If unattended for an extended period of time, the Galaxy should be left in the
folded and strapped position.
3. In anticipation of, or during extremely severe weather conditions, such as tropical
force winds and hurricanes, it is advisable to remove and store the entire Galaxy
structure to protect it from storm-related debris.
9
B
C
D
A
Weight: Approximately 255-265 lbs.
Mast Shape & Diameter: 3.25” x 4.75” Oval
Wall Thickness of Mast: .107”
Arm Wall Thickness: .118”
Center of winder is 3’1” above the ground.
STEP 7:
NOTE: Never turn the winder more than is necessary to open or close canopy, as
it may damage the internal winding mechanism.
1. Turn handle clockwise approximately 90
more times. Make sure the canopy tube
guides into the
fixed housing
. The
canopy is fully open when its perimeter is
taut. (Do not continue turning the winder
past this point, as it may damage the
winding mechanism.)
2. Insert the safety pin into the canopy tube above the lower
hub. The safety pin must be in place at all times while the
Galaxy is in the open position.
3. To close canopy, first remove the safety pin. Turn crank
counter-clockwise until the canopy fully closes. Secure
canopy with strap provided.
4. When Galaxy is not in use, employ its protective cover to
guard the canopy from the elements. Protective cover can
only be used when the Galaxy canopy structure is in the
closed position.
Canopy Tube
Winder Cord
STEP 6:
NOTE:
It is of vital importance that all 8 spacers are installed before operating the
Galaxy. The spacer buttons ensure that the canopy opens easily without the arms
locking. The manufacturer accepts no liability whatsoever for any resulting
damage due to the non-installation of spacer buttons. If spacers are missing,
contact Shademaker to request more.
1. Pull bottom of arms outward and turn winder to open the canopy about halfway. Do
NOT continue to turn if you experience resistance; doing so will damage the internal
pulley and/or winding mechanism. (In most instances, resistance means one or more
of the canopy’s arms need to be pulled further outward.)
2. Examine the struts (14) and arms (15) of the canopy
and locate the spacer holes. Spacer holes will be
located on the strut or arm near the strop where they
connect.
3. Insert spacer into hole and insert screw into spacer.
Tighten spacers into each spacer hole. Remember, all
EIGHT spacers must be installed prior to first operation.
Screw into spacer
Arm
Strop
Strut
S P E C I F I C A T I O N S
Item No.
A
Canopy to
Mast Width
B
Total Height
C
Height to Arm
D
Canopy Clearance
Closed
GALAXY-35S
12’11”
10’1”
7’11”
1’4”
GALAXY-40S
14’6”
9’10”
7’5”
2’
GALAXY-50
16’6”
10’2”
7’6”
1’2”
.118”
.107”
4.75”
Arm
Mast
3.25”
Содержание GALAXY-35S
Страница 1: ......
