2.
8
ASSEMBLY INSTRUCCIONS
Once the adaptor has been assembled you are then ready to fit the TOP CASE. 1- Put the key in and leave in the vertical
position. Slot the rear tongue into the adaptor groove. Fit the front anchorage into its housing.
WARNING.
It is important to
ensure that the case is properly fixed to the adaptor. Make sure you hear the click of the pin as it goes in and that the
front opening lever is correctly positioned
(Fig. 3).
2- To open the TOP CASE, insert the key in the vertical position.
Operate the locking mechanism as shown in
Fig. 4.
Turning the key in a clockwise direction will lock the TOP CASE so
that it can neither be opened nor detached from the adaptor. The key can be removed in either the locked or unlocked
position. 3- To remove the TOP CASE, insert the key in the vertical position, hold the case by the handle, operate the
lower part of the opening mechanism and lift up gently until the anchorage comes out of the case. Then pull to remove
the upper tongue from the adaptor groove
(Fig.5).
5.
3.
4.
The maximum load of the case is of 3 kg.
Then fit the cover (8) by bending it slightly to insert the tongues
(Fig. 2)
