PAGE 3
PAGE 2
SPECIFICATION
MODEL No
SSB500
MAX WORK PRESSURE
110 PSI / 7.6 BAR
WEIGHT
220 kg
DEPTH
WIDTH
HEIGHT
1468mm (889 w/o foot stand)
1778mm
2020mm
MOTOR
230V, 50Hz, 1200W
ABRASIVE GRIT SIZE
40-120 with 5mm Nozzle
AIR REQUIREMENT
25 CFM @ 80PSI/5mm Nozzle
AIR COMSUMPTION
850L/min
GENERAL SAFETY INFORMATION
Any blast cabinet will produce a powerful flow of
abrasive particles. To avoid personal injury and
property damage, study this manual thoroughly before
assembling, operating or servicing this blast cabinet.
Always wear eye/face and hand protection.
GENERAL SAFETY INFORMATION
Before installing the machine, ensure the
availability and proximity of the required power
supply. If an existing circuit does not meet the
requirements for this machine, a new circuit must
be installed. To minimise the risk of electrocution,
fire, or equipment damage, installation work and
electrical wiring must be done by an electrician or
qualified service personnel in accordance with all
applicable codes and standards.
• During operation, do not expose the hands or skin
directly in the line of the blast nozzle.
• Ensure all components seal properly after assembly.
• Do not exceed the maximum operating pressure of
the blasting equipment.
• Disconnect the cabinet from the air supply before
changing accessories or attempting to install,
service, relocate or perform any maintenance.
• Check hoses and air lines for weak or worn
condition before each use. Make sure all the
connections are secure before use.
WWW.SGS-ENGINEERING.COM
