PAGE 5
PAGE 4
ELECTRICAL CONNECTIONS
WARNING! READ THESE ELECTRICAL SAFETY IN-
STRUCTIONS THOROUGHLY BEFORE CONNECTING
THE PRODUCT TO THE MAINS SUPPLY.
Before switching the product on, make sure that the voltage of your elec-
tricity supply is the same as that indicated on the rating plate. This product
is designed to operate on 230VAC 50Hz. Connecting it to any other power
source may cause damage.
This product may be fitted with a non-rewireable plug. If it is necessary to
change the fuse in the plug, the fuse cover must be refitted. If the fuse
cover becomes lost or damaged, the plug must not be used until a suitable
replacement is obtained.
If the plug has to be changed because it is not suitable for your socket, or
due to damage, it should be cut off and a replacement fitted, following the
wiring instructions shown below. The old plug must be disposed of safely,
as insertion into a mains socket could cause an electrical hazard.
We strongly recommend that this machine is connected to the mains sup-
ply via a Residual Current Device (RCD). If in doubt, consult a qualified
electrician. DO NOT attempt repairs yourself.
Plug must be BS1363/A
approved
Always fit a 3amp fuse
Live
(Brown)
Earth
(Green & Yellow)
Blue
(Neutral)
1. Upend the base and use M8x20 hex bolts to attach leg A and leg B,
then mount on the bracket.
2. Use M8x20 hex bolt and spring washers to attach the leg reinforcement
bars.
3. Place the assembled parts upright, then put the funnel in the centre.
Please note: The front of the funnel should be facing leg B.
4. Place the upper cabinet on the assembled stand. The front of upper
cabinet should be facing leg B.
5. Open the double folded door and attach the upper cabinet, big funnel &
bracket together with 22pcs M6x16 round head screws and faced washers.
6. Use 4pcs M6x12 bolts & M6 flange nuts to mount the dust collector at
the backboard of the upper cabinet. Plug the dust collector plug into the
switch box through the slot on the right of the upper cabinet.
ASSEMBLY
WWW.SGS-ENGINEERING.COM
