Installation and Operation
05
06
Power operation and components using
Water cup (add water):
The left and right index finger were inserted into a crescent above vacancy
wet cup, press and hold the remaining fingers around the body, index finger
pressed under wet cup, and then pull out, you can remove the wet cup, un-
plug the humidifier on the back of the cup silicon capsules adding stone tre-
nch Officials pure water or boiled water, added water cannot exceed the m-
aximum tire indicator line, plug silicon capsule well, and then connect the -
power cord into the fuselage, power on.
Connect the power cord, power on
Put the tail end of the power cord into the power cord socket household ox-
ygen bar, and the other end connected to the indoor outlet, after power, the
power switch is turned on, after the first power, microcomputer will autom-
atically start the self-test all the bright lights of a display about 2 seconds
(including the "failure" indicator), colleagues buzzer will sound prompt,
after the self-test, automatically restore the standby mode and displays the
default time "015", "power jack" and "power switch" position, see section
appearance of page four.
Silicon capsule
Highest lines
Installation and Operation
O2
Power on: ON/OFF button
In standby mode, press the "ON / OFF" to wake up the machine and start wo-
rking, and "oxygen" light will be lit, the default length of 15 minutes, turn off
the machine by complex back to standby.
Timing
Click the "timing" until showing the length of time.
After finish working, the display window will return to standby mode and w-
aits for the user to use: If you do not use for more than ten minutes (tempera-
ment cooling system is running for about five minutes), will enter power-sa-
ving sleep state (Note: the premise is not open anion state ), then "Power" w-
ill flash to alert the user who can press the power switch back to the off state
(power switch location, see appearance diagram on page four), you need to
continue to use, press the "ON / OFF" button to start the machine, return to
standby mode and waits for the user to use.
Anion
According to users' needs, you can open anion function, click "anion" to open,
and display "anion" light will be lit (see screen instructions on page five), p-
ress twice means close.
Transfer oxygen
According to users' needs, you can choose different oxygen concentrations,
tap tune oxygen can get a good set of different gears, the display will also sh-
ow the corresponding oxygen flow.
Содержание Household Oxygen Bar
Страница 10: ...13 ISO13485...
