16
Powerlight 1212 version1.01
For a good warm-up, it's sufficient to increase the level until the filament becomes just visible.
Standard factory warm-up setting is 4%
For access to the Set Pre Heat function, proceed as follows:
1.
Select the Set Pre Heat menu from the main menu;
2.
Press Enter to confirm the choice;
3.
Move the square brackets to the CHN field and select the channel whose pre-heat level has to
be set;
(
A
AL
LL
L
set all the channels)
4.
Now move the square brackets to the LEV% field to assign the pre-heat level.
This is expressed as a percentage with a value of between 0 and 9.9%;
5.
Repeat from point 3 to set the other channels.
6.
Press Esc to return to the main menu: the selected data are automatically updated.
2.5 Channel Test
In this Menu, it's possible to check if a channel has any problems. In fact, by selecting the
channel on which there are doubts, Power Light controls its efficiency, allowing to vary its value
from 0 to maximum output and switching off the channels not involved and ignoring any previous
assignments or the presence of an input signal. Only one channel can be checked at a time.
For access to the
Channel Test function
, proceed as follows:
1.
Select the Channel Test menu from the main menu
2.
Press Enter to confirm the choice
3.
Move the square brackets to the
CHN
field and select the channel to be checked
the ALL option executes the test on all the channels at the some time
4.
Now move the square brackets to the
LEV
field to assign the output level
holding down the
button, will bring the channel output to 255(full) in the event of
LEV field=0.
5.
Repeat from point 3 to set the other channels
6.
Press
Esc
to return to the main menu: the selected data are updated automatically.
CHN LEV
1 [0]
<Main Menu >
[Channel test ]
CHN LEV%
6 [4.0%]
<Main Menu >
[Set pre heat ]
www.audiovias.com
Содержание Powerlight 1212D
Страница 1: ...www audiovias com...
Страница 25: ...www audiovias com...