SGM I-2 BLUE POI, Руководство пользователя, Страница: 11 / 24

11
Standalone operation is not running when the fixture is connected to a control device, but when it is pre-programmed with a series of
up to 24 scenes, playing continuously in a loop. Up to three stand-alone programs can be defined and run from the menus, and one of
the programs can be set to run by default whenever the fixture is powered on.
Each of the three available standalone programs contains 24 user-definable
scenes with its own RGB and shutter settings.
Each scene has a definable fade-in time for the transition from one color to the
next, and a wait (static) time of up to 120 minutes and 59 seconds.
To define a stand-alone program, press ENTER → MANUAL → EDITOR.
The standalone mode of the fixture’s startup is enabled by selecting:
ENTER → SETTINGS → STARTUP MODE → SELECT STARTUP MODE →
STANDALONE.
To select the fixture’s startup program, press:
ENTER → SETTINGS → STARTUP MODE → STARTUP PROGRAM.
The chosen program will run its length cyclically whenever the fixture is
powered on.
To run an internal program, go to:
ENTER → MANUAL → RUN PROGRAM.
To stop an active internal program, go to:
ENTER → MANUAL → STOP PROGRAM.
See “Control menu” on page 13-14 for detailed information about the manual menu.
Please note: In POI versions, configuring the fixtures can only be done through RDM.
Using standalone operation
Figure 11: Standalone operation
Most DMX channels: possibility to choose between raw or white-calibrated color (2000K - 10.000K) via the CTC channel.
NOTE: when you adjust the white color temperature, all RGB or RGBW channels (if available) must be set to 100%.
RGB DMX modes: features full color calibration when you mix two or three colors to ensure uniform color between products. Ad-
justing one color does not activate full color calibration.
See all DMX protocols at www.sgmligh.com for more details.
Full Color Calibration and Color Temperature Correction (Q-2 RGBW only)
Setting a static color manually (Q-2 RGBW only)
The Q-2 can be configured to display a predefined and static color.
To set up a static color select ENTER → MANUAL → QUICK COLOR.
Note that, once the MANUAL → QUICK COLOR settings are changed, the fixture will be set by default to automatically start in quick
color mode whenever it is powered on. This can be reset through the menu SETTINGS → STARTUP MODE → SELECT STARTUP
MODE.
The current quick color program can always be stopped going to:
ENTER → MANUAL → STOP PROGRAM
See “Control menu” on pages 13-14 for detailed information about the manual menu.
Please note: In POI versions, configuring the fixtures can only be done by RDM.