SG Models NORTH AMERICAN T-28 TROJAN, Инструкция по сборке

Страница: 26 / 34

North American T-28 Trojan
26
1) Using a modeling knife, remove the
covering from over the precut hinge slot
cut into the lower rear portion of the fu-
selage. This slot accepts the lower rudder
hinge.
INSTALLING VERTICAL STABILIZER
Remove covering.
.
2) Slide the vertical stabilizer into the slot
in the top of the fuselage. The rear edge
of the stabilizer should be flush with the
rear edge of the fuselage and the lower
rudder hinge should engage the precut
hinge slot in the lower fuselage. The bot-
tom edge of the stabilizer should also be
firmly pushed against the top of the hori-
zontal stabilizer.
3) While holding the vertical stabilizer
firmly in place, use a pen and draw a
line on each side of the vertical stabilizer
where it meets the top of the fuselage.
4) Slide the vertcal stabilizer back in
place. Using a triangle, check to ensure
that the vertical stabilizer is aligned 90
o
to the horizontal stabilizer.
Hinge slot.
Epoxy
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.
Epoxy