SFA SaniPump, Руководство по эксплуатации и установке

Страница: 27 / 184

27
station must be checked by the user once a month by observing at least two operating cycles.
The interior of the sump should be checked from time to time and deposits should be disposed of
as necessary.
Maintenance of the pumping station must be carried out by qualified personnel. The following
intervals should not be exceeded:
• 6 months for pumping stations for commercial use.
• 1 year for pumping stations for domesticated use.
NOTE:
Setting up a maintenance plan avoids costly repairs, minimizes maintenance work and
achieves correct and reliable operation.
6. INSPECTION AND MAINTENANCE CHECKLIST
Inspection and maintenance:
• Turn off the power supply.
• Close the supply and discharge shut-off valves.
• Drain the sump.
• Unscrew the connection connecting the drain to the bottom of the pump.
• Remove the pumping station from the tank.
• Check the general condition of the pump, electrical cables, float (switching on, tripping) and the
shredding blade. (Contact SFA Technical Service if a replacement element is faulty).
• Clean the pump and float switch.
• Replace the pump and reconnect the discharge pipe to the pump base.
• Switch back on and open the shut-off valves.
• Perform several operating tests (switching on/off).
List of possible incidents with causes and remedies
Abnormalities
observed
Possible causes ACTION TO BE TAKEN
Does not start up The pump is not connected to a
power supply Switch on the pump
Float blocked in low position Unblock the float
Float out of service Consult SFA after-sales service
Motor out of service Consult SFA after-sales service
Does not turn - buzzing Defective capacitor Consult SFA after-sales service
Blocked hydraulics Clean the hydraulics
Turns but does not
discharge Closed discharge valve Check that the valve is open
Non-return valve defective Consult SFA after-sales service
Hydraulic problem Consult SFA after-sales service