MC_SHELL
5
Installation
2
2
Installation
2.1
Hardware requirements
• PC / AT with 80286-CPU or better
• DOS version 3.3 or later
• min. 640 kbyte memory
• 3.5" disk drive (1.44 MB)
• VGA-compatible graphics card (colour or monochrome, LCD)
• approx. 2 MB free disk space
• an RS-232 serial interface for connecting the inverter
• a serial interface for connecting the mouse
Connect the MOVITRAC
®
31C and the PC together using a commercially available serial interface
cable (shielded!).
01587AEN
Fig. 1: Connection cable between MOVITRAC
®
31C and PC
2.2
Installing and starting the program
Start the installation program
install.bat
which is on the diskette. Follow the instructions
given by the installation program.
Start the MC_SHELL program using the following command:
mc_shell.exe
.
The language selection window appears if MC_SHELL is started for the first time. The various pro-
gram settings (language, colour set) are stored when you exit the program. They are reactivated
when you start the program again.
2.3
Connection between the PC and the frequency inverter
Parameter values are replaced by dashes (---) if the connection is disrupted. In this case, check the
following settings:
IMPORTANT:
Before you connect the PC and the frequency inverter together: Switch off the supply voltage,
otherwise undefined states may be adopted!
RxD
TxD
2
3
5
2
3
5
max. 5 m (16.5 ft)
GND (ground)
Connection to PC (COM1-4)
Connection to USS11A (MOVITRAC 31C)
®
9-pin sub D connector (female)
9-pin sub D connector (male)
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: [email protected]
