SEW-Eurodrive CMS, Быстрый старт, Страница: 10 / 16

10
Addendum to the Operating Instructions – CMS Electric Cylinder
2
Star Vario
Operation of the Star Vario / Star Control Lubricator
2 Operation of the Star Vario / Star Control Lubricator
2.1 Star Vario
2.1.1 During operation
Observe the following points when operating the Star Vario lubricator.
• Perform inspections at regular intervals during operation. Do especially check for
leaks and inspect the state of the lubricator (chapter 8.6.4 of the SEW operating
instructions).
• Refer to the table in section 2.1.3 in case of malfunctions. Do consult the SEW
customer service if the problem cannot be solved.
• Check the fill level of the transparent LC unit regularly
1)
.
• Do observe section 2.1.2 when changing the settings after startup.
2.1.2 Changing the settings
The operating time and the size of the LC unit can only be set when a new LC unit is
being installed. If the setting is to be changed during operation or after the startup, a
new, completely filled LC unit and a new battery set must be used.
If the setting is to be changed during operation, the control and the monitoring electron-
ics are interfered. Thus perma-tec cannot guarantee for a precise lubrication.
STOP
This chapter's content is an excerpt from the current perma operating instruc-
tions
.
SEW-EURODRIVE does not assume liability for the correctness and complete-
ness of the content.
A requirement of fault-free operation and fulfillment of any rights to claim under
limited warranty is that you adhere to the information given in the Star Vario and
Star Control lubricator operating instructions by perma-tec GmbH & Co KG.
1) Lubricant container
STOP
• You must never change the settings of the 4-way code switch during operation or
after startup!
STOP
Do always use a new, completely filled LC unit and a new battery set each time you
changed the settings.
You must never use an LC unit that is already partially empty.
0 0
I