Step 4. Install Pegboard Long Support Bar (#49-A).
Step 5:
Step 6: Install Left and Right Drawer Side Panels (#20-3
and #20-4).
Fit and attach the Left and Right Small Drawer Side
Panels (#20-3 and #20-4) to the Small Drawer
Front Panel (#20-1). Make sure the Left and Right
Small Drawer Side Panels (#20-3 and #20-4) are
placed in all the way making contact with the rear
of the Small Drawer Front Panel (#20-1). Line up
the screw holes and use Screw B (#15) to tighten.
UltraHD Stainless Steel Pegboard Workcenter (Model No. 20267)
ASSEMBLY INSTRUCTIONS
(pg 3 of 7)
Turn the workcenter up right, attach Pegboard
Long Support Bar (#49-A) to the back of the
workbench, line up the screw holes, using 6 pcs of
Screw E (#40) with Washer (#27-B) to tighten.
NOTE: Do not fully tighten the screws. This will
help you make any adjustments to alignment
later.
Install FPR-SS Top Pegboard Panel (#2-D) and
FPR-SS Bottom Pegboard Panel (#3-D).
Attach FPR-SS Bottom Pegboard Panel (#3-D) on
the back top edge of workcenter and Pegboard
Long Support Bar (#49-A), line up the screw holes,
use 4 pcs of Screw F (#41) and Screwdriver (#21)
to tighten.
NOTE: Do not fully tighten the screws. This will
help you make any adjustments to alignment
later.
Attach FPR-SS Top Pegboard Panel (#2-D) to the
Pegboard Long Support Bar (#49-A), line up the screw
holes, use 4 pcs of Screw F (#41) and Screwdriver
(#21) to tighten.
Use 2 pcs Screw B (#15) to fasten the FPR-SS Top and
Bottom Pegboards (#2-D and #3-D) together as left
detail photos shows.
Back
Front
#20-4
#20-3
#20-1
#15
#15
#2-D
#3-D
#41
#49-A
#27-B
#40
