E -
6
Removing the unit
a. Frame
b. Insert fingers into the
groove in the front of frame and
pull out to remove the frame.
(When re-attaching the frame,
point the side with a groove down
wards and attach it.)
c. Insert the levers supplied with the
unit into the grooves at both
sides of the unit as shown in
figure until they click. Pulling the
levers makes it possible to
remove the unit from the
dashboard.
Trim Plate Installation:
Push the trim plate against the chassis until it is fitted
.
You must do this before you install the front panel, otherwise it can't be
attached.
DIN REAR-MOUNT (METHOD B)
Installation using the screw holes on the sides of the unit.
Fastening the unit to the factory radio mounting bracket.
1. Select a position where the
screw holes of the bracket
and the screw holes of the
main unit become aligned
(are fitted) and tighten the
screws at 2 places on each
side.
2. Screws
3. Factory radio mounting
bracket.
4. Dashboard or Console
5. Hook (Remove this part)
Note:
the mounting box, outer
trim ring, and half-sleeve are
not used for method B
installation.
a
b
c
5
2
4
3
2
5