SEVERIN TO 9262, Инструкция по эксплуатации

Страница: 13 / 20

13
Timer
The timer can be used for either selecting a
certain cooking time (up to 60 minutes).
To turn the unit off, turn the switch to
position 0 . To pre-programme the cooking
time, turn the switch clockwise to the
desired time.
To set a time of less than 10 minutes, turn
the timer to a somewhat higher setting fi rst
and then slowly turn it back to the desired
time setting. After the pre-programmed time
has elapsed, an acoustic signal indicates
that the heating elements are switched
off. To switch off the entire appliance, the
heating elements must be switched off as
well.
Indicator lamp
The indicator lamp lights up when the
appliance is switched on. It goes out once
the pre-programmed time has elapsed, or if
the switch is turned back to position 0 .
Pizza stone
∙ Always place the pizza stone on the
middle of the grill rack before inserting
the rack into the appliance.
∙ Preheat the appliance to the required
temperature as described in the section
Operation .
∙ With certain pre-baked pizzas made
from especially light dough, the pre-
heating phase should be shortened;
this is to prevent the bottom layer of the
pizza dough from browning too fast.
∙ After pre-heating, open the door and
use a spatula to place the pizza on the
centre of the stone. The pizza should be
slightly smaller than the stone so that
there is a clear space all round it.
∙ The pizza is ready once the cheese
topping has melted and the bottom
of the dough is slightly brown. Use a
spatula for removing the pizza and
serving it.
Start up
∙ Clean the appliance (see General care
and cleaning ) and remove any packing
materials completely.
∙ Before using the appliance for the fi rst
time, let it heat up for 15 minutes with
both heating elements on. When the
appliance is fi rst switched on, a slight
smell may be emitted. This is normal
and will only last for a very short time.
Ensure suf fi cient ventilation.
Operation
∙ Before using the appliance, make sure
that the crumb tray is fi tted in its proper
position underneath the lower heating
element.
∙ Pre-heat the oven compartment for
several minutes with the door closed,
using both heating elements. Set the
temperature control knob to the required
level and use the timer control to select
the desired pre-heating time.
∙ Place the food to be cooked on the grill
rack. When cooking food containing
fat or moisture, use the baking tray to
stop any drips into the interior of the
appliance.
∙ If the pizza stone is used, it should be
placed straight onto the grill rack.
∙ Close the door, set the temperature
control to the required level and use the