13
Transporting the appliance
To prevent damage to the unit during transport, ensure that all
accessories and components inside and around the appliance
are securely fastened.
The unit must only be transported in its vertical position; do not
tilt any more than 30°.
Once the unit has been positioned, wait for about 30 minutes
before it is connected to the mains.
If the unit has been tilted more than 30° during transport, allow
it to stand in an upright position for at least 4 hours before it is
connected to the mains.
Disposal
This appliance has been manufactured from
recyclable materials. After removing the plug from the
wall socket, the unit should be rendered unusable
by cutting off the power cord before being disposed
of through special waste collection points in accordance with
local regulations. The refrigerant and the chemical agent in
the insulation foam must be disposed of through a competent
agency. Take special care not to damage the cooling circuit
before the unit is handed over for competent disposal.
Guarantee
This product is guaranteed against defects in materials
and workmanship for a period of two years from the date of
purchase. Under this guarantee the manufacturer undertakes
to repair or replace any parts found to be defective, providing
the product is returned to one of our authorised service centres.
This guarantee is only valid if the appliance has been used in
accordance with the instructions, and provided that it has not
been modi
fi
ed, repaired or interfered with by any unauthorised
person, or damaged through misuse.
This guarantee naturally does not cover wear and tear, nor
breakables such as glass and ceramic items, bulbs etc. This
guarantee does not affect your statutory rights, nor any legal
rights you may have as a consumer under applicable national
legislation governing the purchase of goods. If the product fails
to operate and needs to be returned, pack it carefully, enclosing
your name and address and the reason for return. If within the
guarantee period, please also provide the guarantee card and
proof of purchase.
information on the temperature settings, please refer to the
section
Temperature control
.
Trouble-shooting
Certain typical sounds can be heard when the appliance is
switched on. These sounds are:
∙
Caused by the electrical motor within the compressor
assembly; during compressor start-up the sound level will
be slightly higher for a limited period of time.
∙
Caused by the cooling agent
fl
owing through the circuit.
The following table lists the possible malfunctions, their
probable causes and solutions. In the event of operational
probl ems, check
fi
rst whether a solution can be found using this
table. If the problem persists, disconnect the appliance from the
mains power and contact our Customer Service Department.
Problem
Possible cause and solution
The unit is not working.
Check that
∙
power is supplied.
∙
the switch in your home installation fuse box is switched on.
∙
the wall socket is working. This can be done by connecting another electrical device to
the socket and checking for function.
The unit seems to generate
insuf
fi
cient cooling power.
Check whether
∙
too much food has been stored in the unit.
∙
the thermostat is set to position
1
or
2
(in this case, set it to a suitable higher value).
∙
the door is not properly closed.
∙
there is too much dust on the condenser.
∙
the unit is too close to a wall or other object at the rear or to the sides.
The normal operating sound changes
or becomes louder.
Check whether
∙
the unit has been properly positioned.
∙
any objects or obstructions are touching the rear of the unit.
∙
there are any objects on top of the unit which might be vibrating.