SEVERIN HAARTROCKNER HT 6014, Инструкция по эксплуатации

Страница: 7 / 42

Hair dryer
Dear Customer
Before using the appliance, the user must
read the following instructions carefully.
Connection to the mains supply
Th e hair dryer should only be connected to
an earthed socket installed in accordance
with the regulations.
Make sure that the supply voltage corresponds
with the voltage marked on the rating label of
the hair dryer.
Th
is product complies with all binding CE
labelling directives.
Familiarisation
1. Air intake grille
2. Air fl ow control
3. Air temperature control
4. Hanging loop
5. Power cord with plug
6. Cool function
7. Styling nozzle
8. Air outlet opening
Dryer models with volume diff usor and
IONIC function
9. Indicator light
10. Volume diff usor
Important safety instructions
Caution:
z
do not use the
appliance in the vicinity of a
bath, shower or swimming-
pool, over a washbasin fi lled
with water or near any other receptacle
containing water.
Protect the appliance from moisture and
splashing water and do not operate it with
wet hands.
In the vicinity of any water source, there
z
is a risk even when the appliance is
switched off . Th
erefore, always remove
the plug from the wall socket aft er use,
especially if the appliance is being used in
a bathroom.
Additional protection is available by fi tting
an earth-leakage circuit-breaker with
a rated tripping current not exceeding
30mA into your bathroom installation.
Please consult a qualifi ed electrician.
Electric heating appliances operate at very
z
high temperatures. Do not touch any part
of the appliance except the grip. Otherwise
there is a real risk of burning.
Do not use the appliance on synthetic hair-
z
pieces or wigs, as the heat emitted might
cause damage to the synthetic fi bres.
Make sure the air intake and outlet
z
openings are not blocked (e.g. by fi ngers or
hair), and that no fl uff or fi bre particles are
allowed to accumulate in the air intake.
A blockage in the air-fl ow system may
cause the integral thermal safety cut-
out to switch off the appliance. Should
this occur, immediately disconnect the
appliance from the mains power and allow
suffi
cient time for it to cool down before
the blockage is removed and the appliance
is switched on again.
Before the appliance is used, the main
z
body as well as any attachments fi tted
should be checked thoroughly for any
defects. If the appliance, for instance, has
been dropped onto a hard surface, it must
no longer be used: even invisible damage
may have adverse eff ects on its operational
safety.
Th
e power cord should be regularly
z
examined for any signs of damage. In the
event of such damage being found, the
appliance must no longer be used.
Do not operate the appliance if excessive
z
force has been used to pull the power
cord. Damage cannot always be detected
from the outside; the entire unit should
therefore be checked by a qualifi ed
technician before it is used again.
To prevent damage to the power cord,
z
do not bend or kink the cable, especially -
where it leaves the housing,
do not pull on the cord,
-
do not coil the power cord around the -

7