5
Step 3: Make wiring connections.
•
Séura lighted mirrors are equipped with an easy-to-install
wiring fixture disconnect that can be found on the mirror
housing that is now connected to the wall. Refer to your
included drawing package to identify the location of the
fixture disconnect.
•
Connect the whip (extra wires that are pre-wired together)
from step 1 to the fixture disconnect. The connection
accepts AWG 16 - 12 solid or stranded (19 strands maximum).
Using a wire stripper, strip the insulation on the wires back
approximately 1/2”.
•
On Full Length Lighted Mirrors, we recommend routing the
whip from step 1 through the top hole of the center wiring
flange and then connecting the whip to the wiring fixture
disconnect. This will help keep the whip in place so it doesn’t
appear behind the etched mirror glass.
•
Open the fixture disconnect by pushing down on the tab that
connects the top and bottom pieces. Connect wires into the
fixture disconnect using the color code diagram pictured.
Reconnect the top and bottom pieces by sliding them
together.
•
If using a 0-10V dimmable switch, then connect 0-10V
dimming signal directly to the driver dimming control wires.
•
Turn the wall switch to on and verify functionality.
0-10V Dimming
Control Wire
(Positive)
0-10V Dimming
Control Wire
(Negative)
Wiring For Units With 0-10V Dimming
Wiring connections made by
the manufacturer
Field wire connector
Connections to be made by
the installer in the field
Neutral (White)
Ground (Green)
Line Voltage/Hot (Black)
Wiring Fixture Disconnect
On Full Length Lighted
Mirrors, route the whip
through the top hole of
the center wiring flange.
