Version 13.03.2015
Page
7
3.3.
Coding of the rear-‐view camera (only PCM3.1)
It is necessary to code the rear-‐view camera input of the PCM 3.1 to use it for an after-‐
market rear-‐view camera.
1. Turn on ignition
2. Wait until the head-‐unit has booted
3. Press and hold steering-‐wheel button HASH KEY/MODE
4. Press and hold steering-‐wheel button ACCEPT
(observe the sequence!)
5. Hold both buttons. During configuration the red and
blue LED are blinking short inside the CAN-‐box (visible
at the male 8pin Molex connector). The PCM makes a
reset after 5-‐10 sec.
6. Disengage both steering-‐wheel buttons
7. The red and the blue LED inside the CAN-‐Box are
glowing and the menu „Rear-‐view camera“ appears in
the menu OPTION after a successful coding
3.3.1.
Decoding of the rear-‐view camera (only PCM3.1)
It is possible to decode the coding of the rear-‐view camera input as follows:
1. Turn on ignition
2. Wait until the head-‐unit has booted
3. Press and hold steering-‐wheel button HASH KEY/MODE
4. Press and hold steering-‐wheel button HANG UP
(observe the sequence!)
5. Hold both buttons. During configuration the red and blue LED are blinking inside the
CAN-‐box (visible at the male 8pin Molex connector). The PCM makes a reset after 5-‐
10 sec.
6. Disengage both steering-‐wheel buttons
7. The red and the blue LED inside the CAN-‐Box are glowing and the menu „Rear-‐view
camera“ disappears in the menu OPTION after a successful decoding
Steering-‐wheel buttons left
Steering-‐wheel buttons right
BACK
HANG UP
HASH KEY/MODE
ACCEPT
