W A S H I N G
M A C H I N E
5
SM1602
UNPACKING INSTRUCTIONS
(ACCORDING TO MODEL)
1
Washing Machine
2
Owners Handbook
3
Hot and Cold High Pressure Hoses
4
Plastic Hole Plugs
5
Water Inlet Cap
6
Rubber Washers
7
Mesh Filters
8
Hose Crook
The machine must be installed by professionally qualified technicians, according to the manufacturer’s indi-
cations. Incorrect installation may result in damage to persons and property.
The machine can be installed anywhere, provided the temperature in the place of installation is not below 3°C
and the cables and hoses at the rear of the machine are not crushed in any way.
For transport purposes the swinging unit in the machine is blocked using 4
spacers with screws. Before starting the machine these spacers and lock
screws must be removed, and stored for use in the event of a possible
change of location.
Block off the holes with the plugs provided, which can be found in the bag
containing the documents.
N.B. If the spacers fall into the inside of the machine, open the rear
panel, recover them and then replace the panel.
For transport purposes the swinging unit in the machine is blocked using 4
spacers with screws. Before starting the machine these screws must be
removed using a screwdriver.
Insert a screwdriver in the holes and proceed as shown in the figure to
recover the 4 plastic spacers.
N.B. If the spacers fall into the inside of the machine, open the rear
panel, recover them and then replace the panel.
Fig 1
Fig 2
Fig 1A
Fig 2A
