serverLink SL-2C-150, Руководство пользователя

Страница: 26 / 34

26
 Scan Type
There are two Scan Type options for Scan mode:
[Ready PC]: will scan all powered-on computers, except those with the Security “1” setting.
[Ready PC + V ]: will scan only powered-on computers that have a check mark “V”, except those with the
Security “1” setting.

Scan Rate
This sets the display duration for each computer displayed in Scan mode. Available settings are: 3 seconds, 8
seconds, 15 seconds, and 30 seconds.
 CH-Display (Channel ID/Name Display)
There are two options:
Always On : The label with the Channel (i.e., port ID) number and name of the selected computer and/or OSD
status will be permanently displayed on the screen.
Auto Off : The label with the Channel ID and name of the selected computer and/or OSD status will be
displayed on the screen for 3 seconds, then automatically disappear.

Define Hotkey (Define Hotkey for OSD Menu)
The default hotkey to activate the OSD menu is < Scroll Lock >. Select any of the three hotkey options:
< CTRL >, < SHIFT >, or < ALT >.
Operation remains the same, e.g., if you select < SHIFT >, then press< SHIFT >twice activates the OSD, but
you still press < CTRL > to go from the OSD Main Menu to the Setup Menu.

OSD Timer (OSD Timeout)
There are four options for the automatic timeout period of the OSD screen: 30, 45, 60 or 80 seconds. This
represents the amount of time the OSD remains showing. When the time runs out, the OSD turns off.

OSD Position (OSD Display Position)
To set the position of selected computer name and/or OSD status displayed on screen during operation, use
the <
↑
>, <
↓
> to select Up Left, Up Right, Middle, Low Left, and Low Right.
The actual display position can vary depending on the VGA resolution.

Switch Hotkey
This function allows you to switch between computers by using a hotkey only (without bringing up the OSD).
The default value of the Switch Hotkey is OFF. To enable the Switch Hotkey function, select any of the three
hotkey options: <
Num Lock >, < Scroll Lock >, or < Caps Lock >
To switch between computers, press the hotkey twice and then enter the port no. For example, if you selected
<
Num Lock > for your switch hotkey and want to switch to port 4, press< Num Lock >twice and Enter “4”. For
ports with 2 digits (10 to 32), the number keys must be pressed within 2 seconds.

Admin Password
Once the Admin Password is set, you can only access the OSD menu by supplying the assigned password.
The Admin Password is also used to access computers protected with the Security setting. (See F3:
Security). To change the password, enter the OLD password and then set a NEW password. In the event of
the password being lost, you will need to contact your reseller to know how to reset the password.