SERV-WARE DD24-1-HC, Руководство по обслуживанию, установке и уходу

Страница: 12 / 24

www.servware.com
800•768•5953
Service, Installation & Care Manual
MAINTENANCE
Swing Door Replacement and Adjustment:
1. Open the bottom shroud and hold the door, then loose bottom hinge’s screws and take off
the old door;
2. Prepare new door, insert top pin into top hinge, get one bottom hinge to hold the door by the
bottom pin, then fasten bottom hinge securely to the door frame with three screws.
3. Allow the door to freely swing, make sure it swing close by itself with no restriction.
4. Plug the unit in and make sure the lock work well.
5. If not, adjust the door height by adding the plastic spacer/washer provided to the bottom
hinge pin.
Filled CO
2
tanks are potentially dangerous because of the pressure
they contain. If you are unfamiliar with their use or the use of the CO
2
regulator, seek information from your local distributor, or your local
beverage man before proceeding.
Handle all pressure system components with care. Do not use
excessive pressures. Be sure instructions are understood thoroughly.
If in doubt, contact your dealer/distributor for explanation.
CAUTION!
DANGER!
DIRECT DRAW DRAFT ARM INSTALLATION:
On direct draws, the drain is located at the front of the cabinet. To plumb in the drain, connect
P.V.C. pipe to the barbed fitting supplies with the unit.
INSTALLING C0
2
CYLINDER AND REGULATOR:
Make certain that all fittings in system are tight. Always keep the CO
2
cylinder in vertical position.
The recommended pressure for the CO
2
system is 8-10 psi.
11