Serpent Cobra Te, Инструкция по эксплуатации и справочник

Страница: 3 / 36

- This is a highly technical hobby product, intended to be used
in a safe racing environment. This car is capable of speeds
in excess of 80 km/h or 50mph. Please follow these guidelines
when building and operating this model.
- Parental guidance is required when the builder/user of this car
is under 16.
- Follow the building instructions. If in doubt, contact your dealer
or importer.
- Be sure to use the proper tools when assembling the car.
Always exercise caution when using electric tools, knives
and other sharp objects.
- Be careful when using liquids like lubrication oil, fuel or glue.
Do not swallow.
- Follow the manufacturer’s instruction in case you experience
irritation after using the product.
- Be careful when operating the car. Stay away from any rotating
parts such as wheels, gears and transmission. Stay
away from motor, engine and exhaust pipe system or speedo
during and immediately after use, as these parts may be very
hot. We advise to use protective hand cloves.
- Only operate this car in a safe environment, like a
special racing track or a closed parking lot. Avoid using
this car on public roads, crowded places or near infants.
- Before operating this car, always check the mechanical
status of the car. Also check that the transmitter and
receiver frequencies correspond and are not used by
any other racer at the same time.
Check that the batteries of the transmitter and receiver
are fully charged.
- After use, always check all the mechanics of the car.
We advise to clean the car immediately after use, and
inspect the parts for wear or fractures. Replace when
necessary. Do not use water, methanol, thinner or other
solvents to clean the car.
- Empty the fuel tank (depending on model) if needed and
disconnect the receiver battery.
- Store the car in a dry and heated place to avoid corrosion
of metal parts.
- Avoid using this car in wet conditions as the water will
cause corrosion on the metal parts and bearings and
these parts will cease to function properly.
If driven in the wet, ensure that all the electric equipment
is waterproofed and after use, that all moving parts are
dried immediately.
Length after assembly
Each step contains a variety of numbers, lines, and symbols. The numbers represent the
order in which the parts should be assembled. The lines and symbols are described below.
Assembly path of one item into another
Group of items (within lines) should be assembled
first
Direction the item should be moved
Glue one item to another
Press/Insert one item into another
Connect one item to another
Gap between two items
Step number; the order in which you should
assemble the indicated parts
USING THE MANUAL
1
Apply silicone grease (Orange),
Apply graphite grease (Grey),
Apply threadlock (Blue),
Apply silicone oil,