Serpent Cobra GT 3.0, Инструкция по эксплуатации и справочник

Страница: 12 / 41

Page
12
STEP
18
STEP
19
M5X4
M3x8
M3x20
M3x16
2.5x5
Wide
thread
8x11x0.2
Note:
After building the differential with
new gears a new differential case and
bearings, the differential may feel a
little tight. The connected parts need
at least an hour run-time to create
a perfect match. Attention: When
you assemble the diff with too much
initial play, the gears will not run-in
properly and may wear quickly. After
1 or 2 hours of running the car, re-
check the gear-mesh between the
ring gear and the pinion. All parts
should have run-in properly now.
You may ad one or more extra shims
on the pinion or ring-gear, start of
by placing 1 x 0.1mm more, and try
again.
Notes:
1) Use 14x15.6x0.2 shims to
adjust proper gear mesh.
2) Notice orientation of
differential.
Nylock
Nut M3
M3x16
Note proper insert orientation in
the rear bracket, left and right
equal type.
STEP
20
Bag
5
FRONT ASSEMBLY
Use some grease on the
assembly of the gear and pinion