Serenity VPL Скачать руководство пользователя страница 4

Страница: 4 / 4

Ver.1

32. Secure the sensor pan wires to the platform tubes using tie wraps.

33. Re-install the front panel and secure in place using 4 x

bolts.

34. Position the entire vertical platform lift into its final position.

35.

Test the “up” and “down” controls of the unit.

Note

– The upper limit switch needs to be compressed to operate the lift during this test.

Either re-install the top cover or manually hold down the limit switch.

36. If not done above, re-install the top cover, using 2 x

bolts, one on the left and one on

the right side.

37. You are now ready to install the Vertical Platform Lift. Please refer to Installation Manual.

Содержание VPL

Страница 1: ...the two tie wraps that are securing it to the frame Remove the guide bar and place in a location where it will not be damaged For AC and DC Units Steps 6 to 10 Power Cord Installation 6 Inside the tow...

Страница 2: ...lifting the platform 16 Carefully align the platform with tower and push the platform against the tower platform mounting brackets Use the pulley wheel on the worm gear and turn it clockwise to raise...

Страница 3: ...e top of the outer side of the panel tubes 26 Decide if the J Bar should be located on the left or right side of the tower Note It must be installed on the same side the ramp will be installed On the...

Страница 4: ...tion 35 Test the up and down controls of the unit Note The upper limit switch needs to be compressed to operate the lift during this test Either re install the top cover or manually hold down the limi...