2
Safety warnings and general information
•
Use this product only in accordance with the instructions.
•
Children should be supervised to ensure that they do not play with product.
•
This product is not a toy.
•
Do not handle the electrical components with wet hands.
•
Repairs to electrical equipment should only be performed by a qualified electrician.
Improper repairs may place user at serious risk.
•
Water temperature must not exceed 35°C. Top the water levels up frequently during hot
weather.
•
In very low temperatures, drain, dry and protect the water feature from frost, snow and
ice.
•
This product is designed for outdoor use only and should not be positioned where water
spillage may damage carpets or furnishings.
•
Always position on a flat level surface.
•
The chosen location should be free from overhanging trees and bushes which may shed
their leaves in autumn.
•
Select a position considering that the solar panel requires full sun to be effective all day.
If the sun moves behind cloud or is blocked by the shadow of trees buildings or
structure the flow of water will stop. Choose a location that gets full sun during daylight
hours.
•
Always keep the solar panel and pump inlets free from debris by checking them regularly
and clean with clean water and a soft cloth.
•
Ensure that the water level is always sufficient; do not allow the pump to run dry.
•
To eliminate the possibility of water damage around your water feature, check for leaks
and excessive splashing after the initial setup.
•
Occasionally the water pump may make excessive noise, this may be due to the pump
rattling against the side of the reservoir or a small amount of trapped air. Always ensure
that the pump is suckered to the base using the rubber feet. Remove any trapped air by
gently shaking the water pump.
•
This water feature is not suitable for commercial purposes.
Locating the water feature
•
Position the base on a suitable firm, level surface away from areas where it is likely to
become clogged with leaves or debris, which could damage the pump.
•
Unpack the components and lay out on a flat surface.
•
Ensure the feature is only placed on surfaces that will not get marked or damaged by
water splashing. If placing on wooden decking, ensure that the base surface has been
sealed or treated as appropriate. Place in a location where any water spills or splashing
will not reach any other electrical equipment or cause damage.
