www.SereneLifeHome.com
PRODUCT AND MOUNTING DIMENSION
The outside diameter of the toilet drain outlet: 95mm / 3.7”;
The inner diameter of the toilet drain outlet: 87mm / 3.4”
INSTALLATION
Note:
•
Be sure foot pedal, when pressed, touches same flat surface on which toilet is installed.
•
Ensure water supply pressure is no more than 0.4Mpa.
•
Hot water more than 40 degrees is forbidden.
1. To replace an older toilet, turn off water supply to toilet. Remove and drain water supply line.
Remove toilet hold-down bolts/screws. Remove toilet from floor. Remove and discard old flange seal
and hold-down bolts. Verify center of floor flange is at least 200mm/7.9” from back wall (
Fig.1
).
2. If installing a new floor flange, make certain that toilet mounting holes are located at the correct angle
(
Fig.1
). Floor flange must be secured to floor with a minimum of four screws. Insert two supplied T-bolts
into slots in floor flange (
Fig.2
).
3. Verify that floor flange seal is installed on base of toilet. Carefully set toilet over floor flange.
Align holes in toilet base with T-bolts as toilet is lowered onto floor flange.
4. Install floor mounting nuts onto T-bolts. When tight, base should be securely attached and flat against
floor. Attach bolt covers onto nuts
5. Connect water supply line to ½ inch water inlet and turn on water supply line. (
Fig.3
)
Flush toilet several times and check for leaks.
A
B
C
D
E
F
G
H
I
J