Installation (cont):
•
Remove the 4 screws from the front panel (per fig 2 below)
This will allow the front panel to be pulled away from the body.
•
Once the front panel is loose disconnect the 2 connecters as shown (per fig 3) below.
The front panel is then totally disconnected from the body.
•
Line top and bottom of the hole with Gibraltar board or hardboard.
•
If the cutout is not to the recommended size, the wall studs may need packed out with
timber to provide firm fixing surfaces Fit the heater body into the hole by screwing
the 6 fixing screws into the sides of the hole (screws provided)
•
Connect the mains cable as needed.
•
Reconnect the 2 wiring connectors. Ensuring that they are properly in place.
•
Replace the front panel into position and insert the 4 fixing screws in place ensuring that
they are tightened.
Position of screws
Fig 2
Connector 2
Disconnect connectors
Fig 3