Serene Optima S2055, Инструкция по установке и эксплуатации

Страница: 3 / 11

| 3
Operation:
Air is drawn into the heater through the top and side inlets by a tangential fan,
blown over heating elements and then blown out through the bottom louvered
grille into the room.
The heater is controlled by an electronic controller, incorporating an electronic
thermostat and speed control. This controller enables the 5 heat levels which
can be thermostatically controlled
and the powerful 5 speed fan to operate.
To turn ON the heater switch the rocker switch located on base of the
heater to the ON position
(I)
. The heater will beep once.
To start or stop the heater touch POWER on the control panel and the
adjacent blue LED will light.
SETTING THE HEAT CONTROL THERMOSTAT:
To set the electronic thermostat at the required setting, press the selector
buttons as follows:
To Decrease the temperature touch (
-
) button.
To Increase the temperature touch (
+
)
The blue indicators above the selector buttons will be lit to indicate the
temperature setting. When all indicators are lit this indicates the highest
temperature setting.
When only the first blue temperature indicator is lit, the heater will run on LOW
heat.
SETTING THE FAN SPEED
:
To select and increase the fan speed touch the SPEED indicator on the
control panel repeatedly until the desired speed is selected.
To reduce the fan speed touch the SPEED control repeatedly until the
desired fan speed is selected.