SZ-DWS01 v1.0
01/11/12
2
Intallation
Intallation
1. Insert a flat screwdriver into the notch of the casing. Twist carefully to open the front cover.
2. Install the supplied CR2032 batteries properly.
Note
: Please observe the battery polarity to ensure the correct connections while installing the
batteries. Use only the CR2032 batteries for replacement.
3. Attach the front cover to the device.
4. Hold the sensor near the top of the door, close to the opening edge of the door. This is the mounting
location for the sensor.
5. Use either one of the following methods to install the sensor:
•
Remove the back plate of the sensor; use this as the mounting bracket. Use the screwdriver to
secure the back plate to the wall with the screws provided.
•
Use provided adhesive on the sensor. Attach the sensor to the door. Press firmly and hold in place
for a few seconds.
Operation
•
Join
Function