SZ-E(B)SW02(N) V0.4
SZ-ESW02N, SZ-ESW02, SZ-BSW02N Power on/off Switch Installation Guide
This is an electrical power measuring device, which is compatible with ZigBee enabled devices with its embedded radio
frequency (RF) technology. It can also be used with other devices with the ZigBee logo regardless of the manufacturer.
Furthermore, it can work as a signal repeater that will extend the wireless transmission range and increase the reliability of your
network. With a ZigBee compatible gateway and software program, you’ll be able to monitor and inform the energy usage of the
connected appliance.
Specification
Radio Frequency
2.4GHz
LED Indicator
Green x 1
Input Power
120V / 60Hz
Max Load
15A Resistive / 400W Incandescent
Operation Temperature
0° - 40°C (32° - 104°F)
Storage Temperature
-20° - 70°C (-4° - 158°F)
Alarm
Over voltage protection & Over current protection
Package Contents
SZ-ESW02(N) or SZ-BSW02N
ZigBee Energy Switch Installation & Operation Manual
Warnings and Cautions
• Please install and/or use in accordance with appropriate electrical codes and regulations.
• If you are unsure about any part of these instructions, please consult a qualified electrician.
• To reduce the risk of overheating, do not install the device near heat sources, such as fires, boilers or heating vents.
• Do not locate the device facing direct sunlight or humid place.
• This instruction sheet contains important technical data. Please keep it for future reference.
LED
Power
(Green)
On (Green)
- Power On.
Blinking (Green)
- The join function is being processed.
Installation
NOTE
: In order to use SZ-ESW02(N) or SZ-BSW02N in a ZigBee network, the device must be connected to the network via
ZigBee coordinator. Please refer to the instruction sheet for complete information.
1. Put the SZ-ESW02(N) or SZ-BSW02N into a wall receptacle. Make sure the receptacle is working properly. If it is
controlled by a wall switch, please ensure it is set to ON all the time.
2. Attach the appliance to the SZ-ESW02(N) or SZ-BSW02N.
