Sera MU-300 E 187.2, Руководство по эксплуатации

Страница: 51 / 58

51 TA 504
Rev.
3 en 11/2021
Subject to technical modifications! www.sera-web.com
EN
Electric agitator
MU-037300 E 187.2
MU-055450 E 114.2 / MU-075550 E 094.2
Operating instructions
9. Commissioning
9.1 Drive motor
Requirements:
Compare mains conditions (voltage and frequency) with the specifications on the type plate of the motor.
Permissible voltage tolerance (DIN VDE 0530)
for rated voltage + 10%
for rated voltage range +/- 5%
The connecting cable must be dimensioned according the motor characteristics.
Secure the connecting cable with a strain relief.
The nominal motor output applies to a maximum ambient temperature of 40°C and an installation height not high -
er than 1.000m above sea level. The motor output will be reduced if these values are exceeded (see VDE 0530).
Suitable for “moderate” climates according to IEC 721-2-1.
The operation of the electric agitator will heat up the drive motor.
Do not touch the motor during operation!
NOTE!
9.2 Initial commissioning / Recommissioning
Checks prior to each start-up
■
Check whether the fastening screws have been tightened with the specified torque and retighten, if necessary.
■
Check whether all electrical connections are correct.
■
Check the rotational freedom of the mixing element.
10. Operation
As soon as the drive motor is supplied with power,
the electric agitator will start to operate.
NOTE!
The electric agitator does not have an I/O switch.
Devices for turning on and off the electric agitator have to be installed by the operator.