Model 700 Programmer – Operations Manual
3) Install two phone jacks to the right of the MAIN OUTPUT HIGH jacks on the
back panel by drilling two 3/8-inch holes. The jacks should be the shorting
type (Switchcraft 112A). Label one jack as VOLTAGE 2 IN and the other as
VOLTAGE 3 IN.
4) Connect a wire from the shorting lug of the VOLTAGE 2 jack to the output lug
of the OSCILLATOR CONTROL INPUT jack.
5) Connect a 15-inch wire and a three-inch wire to the output lug of the
VOLTAGE 2 jack. Label the long wire at the other end as VOLTAGE 2.
6) Connect the other end of the short wire to the shorting lug of the VOLTAGE 3
jack.
7) Connect a 15-inch wire to the output lug of the VOLTAGE 3 jack. Label the
other end of this wire as VOLTAGE 3.
8) Replace the inside board.
9) Refer to the following page for a diagram of the circuit board. Connect the two
wires to the board as shown.
10) Replace the second board and the back panel.
