SEPTENTRIO AsteRx SBi, Руководство пользователя

Страница: 11 / 38

CHAPTER 3. CONF I GUR I NG THE ASTERX SB I 3
3 Configuring the AsteRx SBi3
3.1 Connecting to the AsteRx SBi3
3.1.1 Connecting via Ethernet using the web
interface
Step 1: Connect the Power and Ethernet cables
Connect the Ethernet cable to the connector labeled ’ ETH ’ on the rear panel of the receiver
as shown in Figure 3-1 and make sure it is connected to a LAN network. Then connect the
power cable to the receiver and make sure the correct input voltage is applied (between 4.5
and 36 V DC).
Figure 3-1: Rear panel Ethernet socket
Step 2: Open a web browser and connect to the AsteRx SBi3
By default, the AsteRx SBi3 has the hostname ’ http://asterxsbi3-xxxxxxx ’ , where xxxxxxx are
the 7 digits of the serial number of the receiver board inside the AsteRx SBi3. This hostname
can be used on a local area network to connect to the AsteRx SBi3 if the
I P address assigned
by the DHCP server is unknown. The hostname can be found on a sticker on the bottom of
the receiver housing. Figure 3-2 shows a screenshot of an Ethernet connection to a receiver
with serial number 9900035 using
’ http://asterxsbi3-9900035 ’ .
Figure 3-2: Connecting to the Web I nterface via Ethernet
11