SEPTENTRIO AsteRx-m2, Руководство по оборудованию

Страница: 17 / 29

17
17
AsteRx-m2 OEM
17
See instructions in the Reference Guide for details on how to configure SD card logging.
The receiver is compatible with SD cards of up to 32GB. The file system is FAT32.
Shortly driving the button pin (pin#25 of 30-pin connector) low toggles logging on and off.
Driving the button pin low for at least 5 seconds unmounts the SD card if it was mounted,
or mounts it if it was unmounted. The SD card mount status can be checked with the
LOGLED pin (see Appendix A).
When powering off the receiver while logging is ongoing, it can be that the last seconds of
data are lost. To avoid data losses, it is advised to first unmount the SD card. This can be
done in two ways:
1. By entering the command “ exeManageDisk, DSK1, Unmount ” , or
“ exePowerMode, StandBy ” before turning off the receiver.
2. By driving the button pin (pin#25) low for at least 5 seconds before turning off the
receiver.
2.11 USB Interface
The user can configure the USB device interface in either USB 1.1 (full speed) mode, or in
USB 2.0 (high speed) mode. USB 2.0 allows higher bandwidth (480 Mbps vs 12 Mbps), but
may not be supported by all host hardware.
By default, USB is configured in USB 1.1 mode. The update files
“AsteRx -m2 _USB_1_1.suf”
and “AsteRx -m2 _USB_2_0.suf” located in the
USB/
folder of the firmware package can be
used to change this. The current USB mode can be checked with the command “ lif,
Identification ”.
2.12 Ethernet
The receiver supports full duplex 10/100 Base-T Ethernet communication. The Ethernet
PHY and magnetics are to be implemented on the host board. Connection with the PHY
is through the RMII interface available on the 60-pin connector.
An example of application circuit is given in the next page. Two options are shown: stand-
alone magnetics or magnetics integrated in a RJ45 connector.