Sephra CF16E, Руководство пользователя, Страница: 11 / 22

12d. STOP button—Stops the motor, causing
the auger to stop spinning. A red LED light
will be lit when the auger is stopped and
the POWER is still on.
Classic and Select models only:
13. HEAT/OFF switch—Turns on the heating
element inside the fountain base. It is set
at a medium heat and should keep the
chocolate warm while it is flowing. A red
LED light will be lit when the switch is
placed in the HEAT position.
14. START/STOP switch—Starts the motor
which causes the auger to spin inside the
cylinder. A red LED light will be lit when
the switch is placed in the START
position.
INSTRUCTIONS INSTRUCTIONS
INSTRUCTIONS INSTRUCTIONS
INSTRUCTIONS
FOR USE FOR USE
FOR USE FOR USE
FOR USE
ASSEMBLY
(SEE ILLUSTRATIONS ON PAGES 4-7)
All models:
1. Wash all of the removable components
and the stainless steel basin in hot, soapy
water. Dry thoroughly. DO NOT ALLOW
WATER OR OTHER LIQUIDS TO ENTER
INTO THE BASE OF THE APPLIANCE
THROUGH ANY VENT HOLES
LOCATED ON THE SIDES OF THE
FOUNTAIN OR THROUGH THE
BOTTOM GRATE. DO NOT IMMERSE
THE FOUNTAIN BASE IN WATER.
2. Place the base of your Sephra Home
Chocolate Fountain on a sturdy, level
surface. If the fountain is not level it will
still operate, but the fondue will gap on
one side and will not have the “curtaining”
effect. The fountain has adjustable feet to
assist you in leveling it if your surface is
not level.
Elite, Classic, and Select models only:
3. Align the notch(es) in the top cylinder
(3a) with the key(s) in the bottom cylinder
(3b) and fit securely together. Slide the
cylinder sleeves (3c) onto the basin pegs
(7a).
4. While holding the knob at the top of the
auger (5) insert the auger into the cylinder.
Make sure the auger fits into place over
the spindle centered in between the basin
pegs. Twist the auger clockwise to make
sure it is properly positioned; you should
feel some resistance as you turn the auger.
If melting chocolate in the basin, wait until
the chocolate is completely melted before
inserting the auger. Failure to do so may
damage the fountain or cause it to
malfunction.
5. Slide the bottom tier (6) over the cylinder
until it stops in position. Slide the top tier
(2) over the cylinder in the same manner
until it stops.
6. Slide the crown (1) into the slots at the
top of the cylinder and over the knob of
the auger. The widest part of the crown
should be at the top of the fountain.
Signature model only:
3. Slide the cylinder sleeves (3c) onto the
basin pegs (7a).
4. While holding the knob at the top of the
auger (5), insert the auger into the cylinder.
Make sure the auger fits into place over
the spindle centered in between the basin
pegs. Twist the auger clockwise to make
9