Seojin Instech SDT-420, Руководство по установке

Страница: 22 / 36

1 1 1 10 0 0 0. C . C . C . Configuration onfiguration onfiguration onfiguration
Notes
Notes Notes Notes
· Two valid data can be transmitted in one second by the digital communication and this should be
considered if the configuration is being performed during the operation.
· The factors altered and saved at a close range or even remotely are written to the EPROM and the
data can be damaged if the power is shut off during writing the data to the EPROM. Therefore, be
sure that the power supply is working appropriately and in a stable status in order not to cause any
trouble during data communication.
ఐ G This is an installation guide for the Point to Point configuration.
To install and operate SDT-420 properly, the calibration should be performed with appropriate
variables according to the installed environment. Some of these variables should be checked and
inputted by a user at the field, whereas some of them would be inputted at the factory before
shipment. SDT-420 supports three different ways of variable editing as explained below.
ݘ Local Configuration & Calibration: By means of the keypad on the display mask of the displayer.
ݙ Remote Configuration & Calibration: By means of the SIEMENS PDM Computer Program.
ݚ HART Communicator Configuration & Calibration: By means of the HART Program.
ྙ
ྙ ྙ
ྙ EMERSON AMS
EMERSON AMS EMERSON AMS
EMERSON AMS ྚ
ྚ ྚ
ྚ SI
SI SI
SIMATIC PDM S/W
MATIC PDM S/W MATIC PDM S/W
MATIC PDM S/W ྛ 375 FIELD COMMUNICATOR
375 FIELD COMMUNICATOR 375 FIELD COMMUNICATOR
375 FIELD COMMUNICATOR ྜ
ྜ ྜ
ྜ SDT
SDT SDT
SDT-
- -
-420 DISPLAYER
420 DISPLAYER 420 DISPLAYER
420 DISPLAYER
),*