v 1.0 091220
Setting the PIN code (setting the buttons combination)
Procedure 1
: While the ignition is ON, disarm the immobilizer by entering your PIN code and
press the acceleration (gas) pedal 10 times (if the pedal is supported in a particular vehicle).
Two blinks of the dashboard indicator will indicate entering into the programming mode. Press
the combination of 1 to 15 supported buttons. Just after entering the combination, turn the car
ignition OFF to save the new PIN code. If you do not switch the ignition OFF within 5 seconds,
the new PIN code will be discarded. The indicator used to show the immobilizer’s status can be
found on the connection diagram.
Procedure 2:
With the ignition ON, enter the 11999 program number using the switch placed
on the PCB – further steps are the same as in Procedure 1.
You must start setting new PIN code within 60 seconds from switching the ignition on.
The engine must be off.
Changing the PIN code
(changing the combination of buttons to disarm the vehicle)
Enter the previous PIN code to disarm the immobilizer. Then, follow the steps for setting the
PIN code.
The PIN code can be reset by setting the 5-digit program number for the vehicle again.
Switching off the auto start-stop system
The auto start-stop is a system that automatically turns off the engine, e.g. when stopping at
traffic lights, and turns it on, e.g. when the clutch pedal is pressed.
To deactivate the start-stop system, switch on the ignition, then press and hold the start-stop
button in the car for 10 seconds. The indicator light on the dashboard will signal that the
memory of start-stop system is turned off with one blink, and will signal that the system is
turned on with two blinks.
The device turns off the auto start-stop system by remembering its last selected mode.
The system will remain off until changed by the user.
