v 1.0 091220
SEO CANpro programming manual
Setting the 5-digit Program number dedicated for a particular vehicle
The main unit’s LED and switch allows you to enter the correct program number for the vehicle.
The program number can be found on the list of vehicles supported by SEO CANpro converter
and on the connection diagram dedicated to the particular vehicle.
Press and hold the button until the LED starts to flash, then release the button; the LED will
start counting (from 1 to 9) to indicate the first digit of the five digit program number. To
program the first digit press and hold the button after the correct number of flashes until the
LED starts to flash again, then release the button. Program the next digits of the program
number in the same way. The LED will flash 10 times after programming is completed
successfully. Then the main unit will then restart, which is signaled by a double flash of the
LED.
Checking the program number:
Press the button briefly, the LED of the main unit will blink out the 5-digit pre-set program
number and then the connection status of the 6 connected CAN BUSes (even if the device is
connected only to 2 CAN BUSes). The number of flashes indicates the status of 6 CAN BUSes:
1 flash
– CAN is connected or has already been connected but device does not receive any data
at the moment (i.e. the CAN BUS is in sleep mode);
2 flashes
– CAN is connected and is receiving data at the moment;
3 flashes
– CAN is disconnected, but requires connection;
4 flashes
– CAN is not supported, no connection required
Updating the software with the O351 programming device
Connect the SEO CANpro device through O351 programmer device to the computer to update
the immobilizer database. For this purpose along with the programmer device we also provide
the PC software necessary for the update. The programmer device can update the database of
supported vehicles.
RHD cars
If, in the car in which you install the immobilizer, it is armed not when the driver's door is
opened, but when the passenger door is opened, you can "swap" the door in the software.
To do this, enter the program number for the particular car, then enter program number 11981.
The return to the standard door recognition occurs when the program number for the particular
car is set.
