5
English
Programmable Electronic Lock
A
Enter the 5-digit factory code on the back of the
owner’s manual.
B
A green light will indicate the code is correct. You
will have 4 seconds to turn the handle to unlock your safe.
Rotate the handle downward to open the door.
This may take a limited amount of force if you have a
water-resistant safe.
NOTE:
Make sure the handle is in the horizontal position when unlocking the safe.
NOTE:
If you exert too much force on the handle, the handle will move without moving the bolts.
When this happens, you will hear a “click.“ DO NOT be alarmed. This feature is designed
to protect the bolts from being over-powered by force. If this occurs, simply exert force in
the opposite direction (lifting up) until the handles “clicks” back into place and repeat
steps 1-3 to open your safe.
A
Close the door and pull the handle upward until the handle
is horizontal. For water-resistant units, additional pressure
to the front left side of the door may need to be applied
prior to rotating the handle.
B
Insert key into the lock, turn to the “locked” position, then
remove the key. Store key in a safe place.
NOTE:
The 5-digit factory code cannot be deleted. However, you may add and delete
additional codes.
NOTE:
If your safe does not appear to be working properly, please check to make sure you are
using NEW alkaline batteries before contacting SentrySafe Customer Service.
Locking your safe
2
3
