SentrySafe CHW30300, Руководство пользователя

Страница: 3 / 15

4 5
English
Battery Installation / Opening
NOTE:
Store code in a secure location (other than in the safe).
NOTE:
SentrySafe offers a secure on-line location for the entry and retrieval of your code.
Go to
www.registermysafe.com
and register your safe.
Insert a credit card, identification card, or another card of a similar size in the
center slot of the battery cover. Once inserted, Remove the card, the battery
cover will pop out attached to your card.
Insert a new 9 volt Alkaline battery in the indicated area.
Reinstall the battery cover by inserting the left side with the two tabs first.
For first time use, enter the factory code, located on the back of this owners
manual, on the keypad. A green LED light will flash to indicate acceptance of
entry. Please allow for a brief delay for the lock to actuate.
Press down on lid and pull up on latch.
Battery Installation
To Open
NOTE: Do not use rechargeable batteries or any other type of non-alkaline battery.
NOTE: If an incorrect code is entered three times, the safe will enter lockout mode.
(Red LED blinks slowly for two minutes.) Please refer to troubleshooting.
Open the safe, then press and hold the reset button, located on the top of
the keypad, until the green LED flashes.
Enter a new 4-6 digit personal code on the key pad. The safe will
acknowledge each acceptable keypress when green LED flashes.
Note: The safe will time out if there is no key entry within 10 seconds.
If the new personal code is 6 digits, the safe will accept immediately. If the
new personal code is 4 or 5 digits, the code will be accepted 10 seconds
after the last key press. The safe will go into Standby mode if fewer than 4
digits are entered.
Once the new personal code is accepted, the safe will automatically save
and exit to Standby mode without additional indication.
Test the personal code before closing the safe. If the code is invalid,
Repeat steps 1-4.
Confidential – Write down personal code, and keep it in a secure location.
Or visit www.registermysafe.com to store your personal code.
Press down on lid. Your safe is now securely locked.
Programming or Resetting Your Personal Code
To Close
NOTE:
The personal code programmed will not be erased when the battery power is removed.
1
2
3
1
2
1
2
3
4
5
1
Programming Your Safe