6
WIRING DIAGRAM & WIRING INSTRUCTIONS
1)
System Power Supply Wiring
The system power supply (adapter) AC 120V or 230V / DC 13V is provided along with the system (please note whether it can meet local
voltage specification). The negative wire is connected to Terminal Pin 1 and the positive wire is connected to Terminal Pin 2.
2)
Install Door Lock with System Power Wiring
The door lock power may be supplied from the system by connecting the positive wire of the lock to Terminal Pin 4 and the negative wire
to Terminal Pin 5. The ACK wire, if your strike has one, is connected to Terminal Pin 6. (The system will supply 12 volts DC at 1000mA.)
3)
Install Door Lock with its own Power Supply Wiring
If the door lock comes with its own power supply or requires more power than what this unit provides, then the power should be
connected as follows:
Remove the jumper wires joining Terminal Pin 2 and Terminal Pin 3. Remove the jumper wires joining Terminal Pin 1 and Terminal Pin 5
as well. The positive wire of the power supply is connected to Terminal Pin 3 and the negative wire to Terminal Pin 5. The door lock’s
positive wire is connected to Terminal Pin 4 and the negative wire is to Terminal Pin 5. The ACK wire, if your strike has one, is connected
to Terminal Pin 6.
OPERATION & SETTINGS
Before operation please make sure the GSM Door Phone is installed correctly. Please also study all button functions before use.
POWER ON/OFF
To turn on the power:
Insert the plug of the power adapter into the DC power jack of door unit and the other end into an AC power outlet. When the power is on, the
system will emit a “beep” sound, show “GSM Door Phone” and software version on screen, then show “Search Network” for a few seconds, and
then go to standby mode.
To turn off the power:
Turn off the door unit by unplugging the power adapter from the AC power outlet.
