PAGE 18
Visitor Calls
When a visitor contacts a resident with the Crown Jewel , the resident can preform various functions using their touch-tone phone.
The default settings are as follows:
1. Press
2. Enter Ring Type (Single Ring [1] or Double Ring [2]
3. Press
Set Visitor Call Ring Sound - 06
Extends Talk Time
Hang Up and Deny Access to the Visitor
Toggles Between Visitor and Another Phone Call
ABC
Activates Relay #2
JKL
Activates Relay #1
WXYZ
KEYS ON RESIDENT'S TELEPHONE
1. Press
2. Enter key that will activate Relay #1 (0-9 or
)
3. Enter key that will activate Relay #2 (0-9 or
)
4. Enter key that will toggle Call Waiting (0-9 or
)
5. Enter key that will extend Talk Time (0-9 or
)
6. Enter key that will Hang Up and Deny Access to Visitor (0-9 or
)
7. Press
Changes the phone key that operates Relay #1 to "1", Relay #2 to "2", the phone key that toggles
between calls to "6", "7" extends talk time and "8" hangs up and denies access to the visitor.
NOTE:
The asterisk key (
) may be assigned to a specific phone key response, therefore, you will be UNABLE
to cancel a command in this programming step.
EXAMPLE:
2
3
4
5
6
7
1
Change the Visitor Call Response Keys - 34
1. Press
2. Enter number of rings (1-24)
3. Press
Set Max Visitor Call Ring Count - 12
IMPORTANT NOTES:
If you make an error during an entry, press the asterisk key (
✱
) to begin again.
The pound key (#) MUST be used to SAVE the data at the end of each programming step.
Time MUST be entered using a 24-Hour format (8:00 AM = 0800, 3:00 PM = 1500 etc.)
2 Short Beeps: Programming input is valid 1 Long Beep: Input is not valid.
Sets number of rings (1-24) the unit will allow before it disconnects the call.
FACTORY SETTING:
12 Rings.
FACTORY SETTING: 2 (Double Ring)
Sets the visitor ring to Single Ring. The phone will ring once
every 6 seconds during a visitor call.
EXAMPLE:
2
3
1
Sets the number of rings before the Crown Jewel
disconnects to 10 rings.
EXAMPLE:
2
3
1