Sentera Controls RDCZ Series, Монтаж и эксплуатация

Страница: 12 / 12

www.sentera.eu
MIW-RDCZ-EN-003 - 29 / 10 / 2020 12 - 12
back to the table of contents
VERIFICATION OF INSTALLATION INSTRUCTIONS
When you first switch on the mains supply, the display will show “888” for 2 seconds.
Then, ”20” will appear and the connected AC motor will run at minimum speed.
If this is not the case, check the connections.
Press and hold the up button until you reach the maximum output value ‘100’.
The AC motor will run at maximum speed. Press the button for 4 seconds until
the display shows a decimal point ‘.’. The RDCZ is now in Stand-by mode, the output
is 0, and the motor will stop.
If this is not the case, check the connections.
Fig. 7 Start-up indication
TRANSPORT AND STORAGE
Avoid shocks and extreme conditions; stock in original packing.
WARRANTY AND RESTRICTIONS
Two years from the delivery date against defects in manufacturing. Any modifications
or alterations to the product after the date of publication relieve the manufacturer
of any responsibilities. The manufacturer bears no responsibility for any misprints or
mistakes in this data.
MAINTENANCE
In normal conditions this product is maintenance-free. If soiled, clean with a dry or
damp cloth. In case of heavy pollution, clean with a non-aggressive product. In these
circumstances the unit should be disconnected from the supply. Pay attention that
no fluids enter the unit. Only reconnect it to the supply when it is completely dry.
RDCZ
RESIDENTIAL FAN SPEED
CONTROLLER