Sentek RT6, Руководство по оборудованию

Страница: 56 / 90

SENTEK
Page 52
calibrated values when connected the relevant
database for one or more sensors,

Unable to connect to the logger with RT6 Logger
Manager or with Data Exchange program.
When determining where in the Sentek RT6 System a
problem lies, it is easier to divide the components into
three major sections and identify which of these areas
could be at fault. They are as follows:
Logging
Facility
Cabling Probes
Once you have been able to determine in which of
these three major components the problem lies, it is
then easier to identify and replace the faulty unit or
repair the fault.
Fault Determination
Symptom Possible Cause Rectification
No communication
with logger Battery low (<12.5V) Solar panel failed or dirty
Fuse blown Replace fuse
Download cable faulty Replace cable
Logger 25 way cable
faulty Replace cable
Logger faulty Replace logger
Main board faulty Replace main board
Jumpers incorrectly set Check positioning of
jumpers
Local/Remote switch
on RT6 front panel
incorrectly positioned
Check and reposition if
necessary
Logger baud rate is not
the same as the baud
rate using to connect Try all baud rates
available.