11
REAR PANEL ASSEMBLY
Locate the two rear, framed glass panels. Each
is marked (LEFT or RIGHT).
The inside edge to
go to the center control panel will be flat. The
outside end to connect to the frame work will
have a 'T' end
Facing the shower from the front, the panels fi t
according to their label.
Now position the Central Tower Panel between the
rear panels.
Align the holes on the rear panels to those in the
tower and fi x in place with the screws provided.
Using 8 of the shorter screws, fi x through the rear
glass panel fi xing holes into the central tower. DO
this on both long sides of the tower.
NOTE: A bead of sealant can be run
between the joining faces of the back
panels and Center Tower to provide an
extra level of water protection.
You should consider doing this on all
panels with meeting faces then simply
wipe off any excess so non will be 'on
show'
Now both glass panels are fully inserted into the
uprights you can tighten up the four corners of the
silver framework which will not hold the glass in
position.
Next you need to fi t the Retaining Clips to hold the
glass fi rmly. Position a clip tight up to the glass on
the inside of the upper and lower rails, mark the
position and drill a small hole then fi x a screw to
hold the clip in place. Repeat top and bottom on
both fi xed glass panels.
CAUTION WHEN DRILLING - ONLY DRILL
THROUGH THE INNER SINGLE LAYER OF FRAME
Re-fi x the SEAL TRIM back on the inside of the
lower curved frame.
GLASS RETAINING CLIPS
Содержание Pure Range
Страница 2: ......
Страница 30: ...FOR TECHNICAL ASSISTANCE PLEASE CALL 0871 526 5926 ...