18
!!!!
Always dispose of battery in accordance with local, state and federal
regulations
3.3
Quick access
3.3.1
Capture an image
After installing the battery, press and hold the power key (≥3 seconds)
until the display comes on. After approximately 50 seconds, the power
on routine will finish and the camera will start its measurements.
Remove the lens cap and aim at the target. Adjust the focus for the
clearest target thermal image.
Press A key for auto calibration to get the best image
! NOTE
: Failure to properly focus the camera will result in increased
measurement error.
When the image quality become worse or ghost
image appeared, please press button A for a long time to compulsion in
force.
3.3.2
Temperature measurement
If no measurement cursors are on screen, add a measurement spot,
area or line by pressing
MENU
and selecting Measurement. Press
CONFIRM
and scroll left or right to select the proper measurement
parameter. Aim the cursor indicator onto the target object on the
screen. The temperature will be displayed in the upper right corner of
the screen. For highest accuracy measurements, force a calibration
cycle by pressing the
A
key for 3 seconds until “
Calibrating
” appears
in upper left portion of display.
If you want to measure the current thermal image in detail, press S
key to freeze the image for on-screen analysis. Save the image if
future analysis is desired.
If the target object’s temperature is lower or higher than the limits of